Overview DSTD/MS SATELLITE & FTA DIPLEXER - JONSA Mix or separate Satellite and Terrestrial signals for RFdistribution Power passing from SAT IF Out to In and IN to SAT IF Out Terrestrial frequency: 5 - 862MHz Satellite frequency: 950...

Satellite/Cable and Free-to-Air Diplexer Combine FTA and Satellite/Cable transmission into one coax cable Split FTA and Satellite/Cable transmission from one coax cable into two Eliminates interference between Satellite/Cable signaland FTA...

Overview 09MM-FD09 VHF / UHF DIPLEXER WITH SWITCH & 5G/4G FILTER Features: VHF/UHFVHF/UHF Diplexing Filter with Input Switch diplexing filter VHF frequency range: 174-230MHz UHF frequency range: 520-694MHz ...

- Connects 75 Ohm coaxial cable through ""F"" Type connection to 300 Ohm terminals on aerial with insulated wire leads.

The DC blocker is used to block dc voltages while allowing RF signals to pass. They are required when remote voltages need to be stopped before entering the inputs and outputs ofother components in systems.

  MS2X8 MULTISWITCH 2 WIRE 8 OUT Features For 8 subscribers or 4 IQ subscribers Remote powered by satellite receiver The IF polarity selection is controlled by the remotevoltage provided by the receiver: < 14.5 V =...

  MS2X4 MULTISWITCH 2 WIRE 4 OUT Features For 4 subscribers or 2 IQ subscribers Remote powered by satellite receiver The IF polarity selection is controlled by the remote voltage provided by the receiver: < 14.5 V =...

Attenuators are used to lower high signal levels of both FTAand Sat signals to the specified input levels required by equipment like set top boxes and amplifiers. This attenuatorwill reduce the signal level by 10dB (large amount). F Plug to F Socket...

Attenuators are used to lower high signal levels of both FTAand Sat signals to the specified input levels required by equipment like set top boxes and amplifiers. This attenuatorwill reduce the signal level by 3dB (small amount). F Plug to F Socket...

An attenuator reduces the amplitude or power of a signal without appreciably distorting its waveform. In that, it is effectively the opposite of an amplifier. 9 dB F-Type With AC/DC power-pass

An attenuator reduces the amplitude or power of a signal without appreciably distorting its waveform. In that, it is effectively the opposite of an amplifier. 20 dB F-Type No power-pass

An attenuator reduces the amplitude or power of a signal without appreciably distorting its waveform. In that, it is effectively the opposite of an amplifier. 16 dB F-Type No power-pass