This unit is designed as an isolation unit to prevent hum loops in audio systems. Balanced 10kΩ to balanced 10kΩ 3 pin male XLR with ground. lift and capacitive coupling switch.
Dimension Drawing
This unit can be used for balancing a line level signal (converting a 10kΩ unbalanced signal to 600Ω balanced) and as an isolation unit to prevent hum loops in audio systems.
Dimension Drawing
This unit is designed as an isolation unit to prevent hum loops in audio systems. Balanced 600Ω to balanced 600Ω 3 pin male XLR with ground, lift and capacitive coupling switch.
Dimension Drawing
Balanced 600 Ohm 3 pin female XLR to unbalanced 10K Ohm 2 x RCA with level control. +10dB max signal gain. Steps up input signal by factor of 16, ie 20mV in = 320mV out.
Dimension Drawing
The A2387A is a high-power, dual-source, autoformer based speaker selector. Dual source operation makes two different amplifiers/receivers drive selected speakers simultaneously. Each speaker pair...
Designed for installations using several pairs of 8Ω speakers connected to one amplifier. Adjustable impedance protection allows multiple pairs of speakers to be connected without overloading the...
These controllers can be configured as either five single inputs to five outputs or one input to five outputs. Each zone has a 100W load capacity, with a total panel capacity of 500W. The 100W model...
This Attenuator Volume Control 5 Zone Evac 40W / 100V Line can be configured as either five single inputs to five outputs or one input to five outputs. Each zone has a 40W load capacity, with a total...
This controller has been designed to install to a double electrical flush box or wall mounting block. Massive 100 watt capacity available. 11 settings plus off. Fitted with a 24V override relay.
In-line volume controls for line level sources such as CD player, Tuner, MP3 player etc. Both models utilise a 10kΩ logarithmic potentiometer. Perfect for board rooms & lecture theatres. Standard...
In-line volume controls for line level sources such as CD player, Tuner, MP3 player etc. Both models utilise a 10kΩ logarithmic potentiometer. Perfect for board rooms & lecture theatres. Standard...
Connects via figure 8 cable to the “remote volume” terminals of the amplifier. Enabling overall volume to be adjusted as required.
Features a PCB jumper to reverse the volume control direction...
A combination of level control attenuator with 11 positions and 5 way audio source selector. Designed to control 100V line speaker systems, this attenuator is fitted to an industry standard wall...
