This compact PWM DC motor speed controller is designed for precise and efficient control of DC motors and compatible LED loads. Operating across a wide 5V to 16V input range, it provides smooth stepless speed regulation using pulse width modulation while maintaining high efficiency. The onboard potentiometer also acts as the power switch. Turning it clockwise clicks the module on, with further rotation adjusting output from approximately 1% to 99% duty cycle. At the fully counterclockwise position, the controller is switched off.
The module supports up to 10A continuous current and can handle short bursts of up to 20A for less than 10 seconds. With a peak efficiency of up to 98% and extremely low standby current, it is well suited for continuous use in compact and power sensitive applications. While primarily intended for DC motor speed control, this module can also be used as an LED dimmer. When dimming LEDs, ensure the LED is suitable for direct DC power and that appropriate current limiting is used, as LEDs connected directly without protection may be damaged. An ideal solution for DIY motor control, fan speed regulation, and small to medium power LED dimming projects.
Please Note: The module must be connected to a load for the output to vary correctly. Measuring the output with a multimeter without a connected load may not show a changing voltage. For LED dimming applications, a suitable current limiting resistor or driver is required to prevent damage to the LEDs.
Features:
- Wide DC input voltage range from 5V to 16V
- PWM stepless speed control with 0% to 99% duty cycle
- Up to 10A continuous current output
- Short peak current up to 20A for less than 10 seconds
- High efficiency design with up to 98% efficiency
- Potentiometer with integrated on off switch
- Suitable for DC motors and compatible LED dimming applications
Specifications:
Input voltage: DC 5V to 16V
Continuous current: 10A
Maximum short current: 20A
Control method PWM speed regulation
Quiescent current approximately: 0.002A
Dimensions: 30 × 20 × 14mm (excluding potentiometer)
