Genlamp IP67 5050 RGB Magic 12 Volt LED Strip Light 5m Roll

This LED strip features 5050 size LEDs which can produce a huge array of colours and visual effects with adjustable chaser effects, speed and brightness - far more than most standard RGB strips. Stripping is housed in 15 x 4mm rectangular plastic tubing which is rated at IP65 (tubing can be removed if required). Can be cut to length every 3 LEDs or 100mm. Roll only. Controller and remote sold separately. There are two options for controllers: The first is X3219 which is a remote control offering 16 selectable colours, adjustable brightness, speed of colour change and 4 effects (flash, strobe, fade and smooth transition.) One X3219 Controller is required for every 5m installed. The other option is X3219A which offers 358 built-in lighting effects with adjustable brightness and speed, supporting up to 2048 pixels. See accessories listed below Sold per 5m roll. Note: Care should be taken when cutting waterproof IP65 LED strips to ensure the protective casing does not let moisture in. See it in action... Operation Note: If remote is displaying incorrect colour LED's try the following process to reset it. Once connected turn off (remove power) via controller - then press reset on remote. Lights should turn on white. Then press the speed button until all colours have been cycled through, once then start cycling through again. Stop on the first green. This indicates the correct mode, and all remote colours should change to the correct corresponding colour on the LED strip. Then press ON. If the colours are still not synced, repeat this process to load the correct code set. The unit will hold this "correct mode" even if power is removed. However if the reset button on remote is pushed then this procedure will need to be carried out again.